World press machine manufacturer 2022? Synchronization system: The machine consists of a mechanical synchronization mechanism composed of torsion shats, wingarms, jont bearing, ec, with simple structure, stable ano reliable performance, and high synchronization accuracy. The mechanical stop is adjusted by the motor, and the numerical control system controls the value; Stopper mechanism: The stopper is driven by a motor, and the two screw rods are driven to move synchronously through a chain operation. The numerical controlsystem controls the size of the stopper. Read extra information on world press machine.
The imprint bending is the same as the bending of the bottomed die, except that the front end of the punch is processed to the required bending radius, and the gap between the punch and the die at th bottom of the stroke is smler than the material thickness. Since enough presure approximately 10 timesof fee bendig is applied to force the front end of the punchto contact the material, springback is basically avoided.
We can provide installation service for all the sold out machines at customer factory. Small machines can be shipped assembled and some big machines must be shipped disassembled. That is why we provide installation service to our customer. World has been committed to the development and production of power press machines since it was established in 1953. More than 100 experienced engineers are working in the three R&D centers, one in Shanghai, one in factory and another one in Ningbo.
Carefully consider the material grade and the maximum processing thickness and lengh. If most of the work is lowcarbon steel with a thickness of 16 gauge and a maximumlengh of 10 feet (3.048 meters), then the free bending force does not need to be greater than 50 tons. However, f yu are engaged in alarge number of bottomed die forming, perhaps a 160-ton machine toolshould be considered. Assuming that the thickest material is 1/4 inch, a 10-ot re bending requires 0 tos, and a botomed die bending (corected bendg) requre atleast o00tos. If mos prtsare 5feet or shorter, the tonnage is almost halved, which greatly reduces the cost of purchase. The length of the part is very important for determining the specifications of the new machine.
The reason for this is the significantly lower modulus of elasticity of aluminum compared to stel. However, i ore to realise reaterdegrees o defration, sale straightenig rolls must be used. With high-strength steels, on the other hand, a conflict of objectives arises. On the one hand, their high yield strengths require enormous forming forces and torques; on the other hand, small straightening rll diameters are als ned here to ahie asufficent egeo p lstificaton.The straightening o both aluminum and high-strength steels therefore requires a forming geometry adapted to the respective product. This is essentially determined by the number, diameter and spacing of the straightening rolls. See additional information on pressmachine-world.com.